I have been talking to Jim Pierce about making Tubular front control arms for our cars and he has been interested in this for awhile as well. We figured we could see who would be interested in a set of these if they were actually produced.
The design will consist of a rod end in the front mount,a pin in the back to use with your bushing and bracket. It will be built to mx3 size with a plate for a stock balljoint. This allows for you guys to use the rx7 ball joint or the one you currently use depending on the pin size. The swaybar mount will be a tab that a rodend could be attached to with your endlink threaded into it.
There is not a set price yet, we are aiming for 3-400.
Lets hear what you guys have to say
The design will consist of a rod end in the front mount,a pin in the back to use with your bushing and bracket. It will be built to mx3 size with a plate for a stock balljoint. This allows for you guys to use the rx7 ball joint or the one you currently use depending on the pin size. The swaybar mount will be a tab that a rodend could be attached to with your endlink threaded into it.
There is not a set price yet, we are aiming for 3-400.
Lets hear what you guys have to say
Comment