If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
send him a pm, i exchanged several messages with mike today. hes around
-jon
Escort GTR -- 11.87 @ 117.6 mph -- 320 HP / 325 Ft. Lbs. @ 23 PSI
... The first FWD BG with a Toyota E153 transmission conversion in the USA! Looking for BP x Toyota E153 adapter plates? PM me or contact me on Facebook: Riel Performance Parts
3 month bump, was in idiot and didnt ask for one back then, now i need one
Block is almost done, cylinders are overboard for Weisco pistons, pro gram billet main caps have been line bored, and my chinese EDT rods have been machined to right specs. Everything has been balanced.
these rails fit perfectly by the way guys, you can see mine installed on page 31 of the "what did you do to your BG today" thread
Escort GTR -- 11.87 @ 117.6 mph -- 320 HP / 325 Ft. Lbs. @ 23 PSI
... The first FWD BG with a Toyota E153 transmission conversion in the USA! Looking for BP x Toyota E153 adapter plates? PM me or contact me on Facebook: Riel Performance Parts
no hes been in hiding because he is building my downpipe! :D
without it i cant come to the meet! lol
Escort GTR -- 11.87 @ 117.6 mph -- 320 HP / 325 Ft. Lbs. @ 23 PSI
... The first FWD BG with a Toyota E153 transmission conversion in the USA! Looking for BP x Toyota E153 adapter plates? PM me or contact me on Facebook: Riel Performance Parts
If he wont ship it to you I should be able to. I am in the US Army in Germany so I can use the German Postal system.
I need one too. I am first I tell ya, look at my other posts
PLEASE PLEASE PLEASE PLEASE :D
Block is almost done, cylinders are overboard for Weisco pistons, pro gram billet main caps have been line bored, and my chinese EDT rods have been machined to right specs. Everything has been balanced.
He has to make them. Last time I talked to him he was busy as hell with other projects, hence the reason why no fuel rails. I dont know if he will ever biuld them again but if he does, they wont come with any fittings.
Block is almost done, cylinders are overboard for Weisco pistons, pro gram billet main caps have been line bored, and my chinese EDT rods have been machined to right specs. Everything has been balanced.
I have them, I will try to make two over the weekend let me know what rails you guys need. Yes-N if you want a rail with no regulator prevision its going to be a delay I will have to order more rail to make yours all the ones I have made up are to run the stock regs. Let me know guys.
Comment