If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi guys, i would like to put the oil temperature sensor in the hole of the oil pump (see photo), could someone tell me what thread is it? NPT? BSP? Taper? Parallel?
Thanks
Yes is to compare but if someone know before...better. Here is difficult to find NPT for verify the thread.
However on the block the knock sensor thread is BSP, maybe also here is
Comment