hey does anybody know where i can get the plastic trim pieces that go 1 on each side on the 1990-94 323 hatchback between the windshield and door can anybody tell where or how other than the dealer where i could get them
-
-
Other than the dealer, I would say your best bet is to take a visit to your local import junkyard
PS: be careful when removing them, I hear they are quite brittle
-
hit up the yard in ft. lauderdale by the airport I seen a few 323's there a week or so agoOriginally posted by jturbo323 View Post"Discontent is the first necessity of progress."
-Thomas A. Edison
"There is a fine line between ballin' on a budget, and dreamin' on an empty wallet."
*Junked* 92 mx3, BP swap- milage whore, beaten up and down the east coast
*Junked* KLZE powered 323 on Megasquirt 1
172.60HP & 156.93 TQ with only headers and short ram intake. back under the knife for a BPT swap.
New Daily stock 1.6L 1999 Mazda Protege LXComment
-
I'm going back to U-Pick-It this week and there were 4 323's there last time and I'll pull them all off if I can!
MrH.
Looking for an Interplay Bumper!!!!Comment
-
Does anybody here fab these? I've seen a fair amount of discussion about them and they seem to be rare/high demand parts. Just a thought.
But hey, I'm a Protege guy, so I don't know.1990 Protege 4WD
GT-X BP26 swap [AT->MT]|Cup holder cut to fit|Synthetic gear oil|Synthetic brake fluid|Corksport SS brake/clutch lines|Mazdaspeed HV oil pump|GT-X front STB|Corksport type I rear STB|Matching full-size spare wheel|Homebrew Brass shifter bushing|Speed Source brass shifter cable bushings|EDM headlights/corners|FMIC|EDM cabin vents
1 3 5
├┼┤
2 4 R
Seeking: Canadian 4WD seatbelts.
Comment
Comment