I've been building an over engineered fog-light harness trying to make it as OEM as possible. Today I pulled the engine bay fuse box to try to use the empty spot in-between the btn and cooling fan fuse.
The power wire is already ran to it so it only needs a terminal connecting to the spade that's already there. Unfortunately it was much larger than any of the spade terminals I had. So I buttend everything up and took a 40min drive to home-depot because it was rush hour and I will have a lot of time to kill tomorrow with my car so I wanted to be able to finish this part.
Their largest spade terminal was smaller than the one I had.
Going to have to hit up the junkyard and snatch one from a miata harness.
Doing things the right way sucks.
The power wire is already ran to it so it only needs a terminal connecting to the spade that's already there. Unfortunately it was much larger than any of the spade terminals I had. So I buttend everything up and took a 40min drive to home-depot because it was rush hour and I will have a lot of time to kill tomorrow with my car so I wanted to be able to finish this part.
Their largest spade terminal was smaller than the one I had.
Going to have to hit up the junkyard and snatch one from a miata harness.
Doing things the right way sucks.
Comment