how do u wire regular car speakers
-
-
You cut off the stock plug (leave enough so you can reconnect it later on if needed), strip about half an inch. Strip 1/2" from the new speakers' wires. Slip on a heatshrink tube long enough to cover the stripped area. Twist together the wires, making sure you have the right polarities. Put the heatshrink into position and heat it to seal.
Or, I used bullet style crimp-on connectors, but they're not as good as the method described above, I wouldn't do it again. It's not bad though, the connections are solid and fairly well insulated this way as well, and it's not such a pain to undo. Also, you can leave the connectors on the stock wires, add some to the stock plug's wires and it will be a "snap" to reconnect the stock speakers.
Comment