If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Went to the yard and continued to pick apart the Neo
Grabbed the front seats and a pile of dash/interior stuff.
The plastic is the same color as my car
I need to get them recovered.
Not just from "today" but over the last few days ive managed to put the g-tranny back together with the mfactory diff,remove the f-box,replace rear main seal and re-silicone the the carrier for that seal,Install and torque the F-1 Racing Flywheel and install the clutch and drop the subframe to remove the rear mount for filling.
The right side axle is going to be an issue.It doesnt line up as suspected.
The Neo doner car has a different part number for that shaft than a BP 96 protege.So i dunno what to do here.
Used windshield urethane rubber to fill the voids in the front and rear mounts,then gave them a blast of rubberized
undercoating .I forgot how unfun it is to install a tranny on the ground.Regardless its in and I have a clutch.
The slave cyl was too far away so i made a plate to bring it closer to the fork .
Comment