WTB: Misc. 5 speed parts

[Ace]

We started on the swap today, and thought that the local yards would have everything we needed.. well we were wrong and my car is now 100 miles away from my house in Jinx's garage. It can't go anywhere till I get all these parts and get the car running. So you should help your friendly moderator and sell me the parts I need which are

-Pressure plate bolts
-Hydraulic clutch line- all of it, brake master to clutch master, clutch master to the flex line, and then the hard line that goes to the slave.
-Starter
-Axles
-Escort GT speedometer cable

I may add to this list overtime, please check back.

[bomdoutscort]

What part of the clutch line do you need? I have a master cylinder also. If i can figure out how to get the speedo cable out i have that also. I haven't removed the cluster in a long time. I have a drivers side axle that needs a new boot and probably some more axle grease. Your probably gonna need a half shaft also

[MD323]

In the mazda BGs you can reach up in the dash between the brake and clutch and you can feel for the cable, squeeze the clip and it comes off.

He need the master cylinder and the hardline between the master and the flex line as well as the flex line.

[yunvmyegt]

i have the clutch line, clutch and pp, probably the bolts maybe a starter, and i know i have the clutch hard line which looks almost new.... let me know and well make a deal....

[bomdoutscort]

Ok i got you. I have all that.

[bomdoutscort]

Ok so here's what i have. I have a starter that might work(will get tested at autozone) escort GT speedo cable, a passenger side axle(needs a new boot and grease), a clutch master cylinder, and the lines for the clutch master cylinder all the way to the slave.

[Ace]

I'll let you know bomd.

[jinx]

I'll probably get you the egt speedo cable wednesday when I go up to the yard with shawn to get you those springs and anything else I see that we need.

[Ace]

ok, get the starter from the one EGT too. and get any of the hard lines you can, so we can use them as a template. If we have to we can get the bulk lines and some flare fittings and bend them up.